Radon is a radioactive gas. It is odorless and colorless. You can’t really see radon gas, neither can you feel its presence, smell it or touch it. The only way to find out if your house has a high concentration of radon gas is to get it checked out by a radon test.  One really good source for checking your house if you have high radon levels  would be radon abatement.

From a chemical point of view, radon is not really harmful at all since there is no chemical in the body that reacts with the radon gas but when it comes to talking about the physical point of view. Radon is really a harmful gas. It is present all around us in low quantities but that doesn’t matter, it effects when its present in a room and you’re exposed to it for a long time. Radon is the second biggest cause of lung cancer in the United States of America. Nearly twenty-one percent of the deaths caused by lung cancer is because of radon exposure.

Since there has been such a big increase for awareness and protection more and more buildings and homes, schools, etc are being fixed with radon mitigation systems to extract out the gas and protect the people from lung cancer.

Something to note, the devices used for testing radon and measurements are different. This is the process of installing the radon reduction system which helps extract the radon and free it out into the environment stopping it from being trapped inside the house.

  1. Test the sub-slab

It is necessary to determine the air flow from under the surface since this helps ensure that the place you’re about to install the system it will be effective as well. If one place doesn’t work since the soil is spread all over the place under your house than you can make two or more points where you can extract the gas from.

  1. The cracks and holes in wall

The cracks and holes in the wall make up for a big problem. Even if you put up the whole system and it starts working well the problem you will face is with the cracks and holes in the wall since the radon gas will seep through the walls and straight into the house so setting up the suction system would be of no importance then. Use some sort of sealant to cover up holes and cracks.

  1. Install a pipe

Install the pipe from the ground straight towards the roof. This will extract the air straight out of the house.

  1. Install a manometer

This is used so that you can check if the system is working well and the gas is being extracted or not.

  1. Fan

For this, you need to cut the pipe in half and fit a fan in between so it helps suck the gas and channel it out of the house.

Conclusion

In short, this is the way to fit up to a radon mitigation system in your house. You can do it yourself too but it’s preferred if you get it done by a professional. Try out Radon abatement if you’re interested.

How to install a radon system in the house